Bizi Takip Edin

Electronic EGT Controller

2,505.59

EGT K TYPE Thermocouple Amplifier Controller & Gauge & Analog Out

  • Brand: Bosphorus Innovations
  • 100% of domestic production is Turkish property.
  • Gives a warning light when it starts to work, you can adjust it at any time
  • 16-bit microprocessor controlled and equipped with state-of-the-art digital hardware.
  • Electronic circuit with SMD technology.
  • Installation is done by the retrofit method.
  • The controller uses an industrial microcomputer control system, stable performance, simple operation.
  • Using the K-type thermocouple temperature probe, with easy installation, high temperature, long life, and other advantages.
  • 2-year warranty

Product Description

  • Input voltage: DC 12V
  • Motherboard Power: <3W
  • Temperature Controller Board Temperature range: -30 ~ 999℃
  • Measuring input: K-type thermocouple
  • Temperature measurement accuracy: ± 1 ℃
  • Analog output: 0-5V (For ECU’s, data loggers and etc.)
  • Output Type: one relay output
  • Display window: 38 * 20mm
  • Size: 79 * 51 * 27mm

Included:

  • EGT K TYPE Thermocouple Amplifier Controller & Gauge & Analog Output
  • Optional EGT Sensor/ K Thermocouple Probe
  • 1 meter/3.3 ft cable
  • Instruction Manuel

Ürün Klavuzu

Stokta (stokta kalmasa da sipariş verilebilir)

Açıklama
Değerlendirmeler (0)

Settings:
Power emperor window shows the current real-time temperature
Ent: Enter, according to a determined set value, press switch can be realized.
SET: Setting key, press once to enter the main menu (F1-F5)
” ” Plus key: increase the value display panel
“-” Minus key: decrease the value of the panel display

Internal Setting Description:
Press the SET panel display F1-F5, can be set for each parameter by key operation
F1: Set the desired temperature
F2: Setting the operating mode H = Heating, C = [refrigeration] This step is very important.
F3: Hysteresis setting, which is the number of degrees down to work again.
F4: Temperature correction, real-time display value = value correction
F5: High-temperature alarm, reaches this temperature the thermostat will prompt alarm

Instructions
Set the target temperature value F1 (stop temperature)
Setting the F2 pattern, H is heating, C is Cooling
Setting back the difference, (the number of stop-start to fall again)

Display:
LLL / HHH: Sensor fault or sensor not connected
Mode / Cooling: lights shows that the current mode is a cooling mode
Mode/heating: Lit describes the current mode is a heating mode
Start: Lit explained that it had started the output relay is closed

Note: Relay output interface is a switch when it working, these two ports are connected. If not work, these two ports are not connected.

Değerlendirmeler

Henüz değerlendirme yapılmadı.

Sadece bu ürünü satın almış olan müşteriler yorum yapabilir.

Yardım merkezine hoşgeldiniz.

E-posta gönderin
WhatsApp
Sizi Arayalım
Mesaj gönder
1
Merhaba
Nasıl yardımcı olabiliriz?